Control Panel - Prem-I-Air EH0539 User Manual

Control panel

Note:
If wireless remote controller is lost, open the surface panel and operate manually.
1 POWER BUTTON
Operation starts when pressing this button, and stops
when pressing this button again.
SWING BUTTON
2
Activate the automatic air swing function.
FAN SPEED BUTTON
3
Select the fan speed HIGH, MID, LOW and AUTO in sequence.
TEMP/TIMER BUTTON
4
Press the keypad to increase the set (operating)
temperature of the unit. And Press the keypad to
decrease the set (operating) temperature of the
The temperature setting range is from 16~30℃
Timer can be set by pressing / button. Timer can be
set in 0.5hour increments between 1 and 10 hours, or in
1hour increments for 10 hours or above after each push
on or button.
5
SIGNAL RECEIVER
MODE BUTTON
6
Select the operation mode, AUTO, COOL,
DRY (for reverse cycle model) or COOL,FAN, DRY
(for cooling only model).
FILTER BUTTON
7
This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation and
cooling. The LED (light) will illuminate after 250 hours
unit.
of operation. To reset after cleaning the filter, press the
"Check Filter" button and the light will go
FAN,
off.