Updating The Operating System Using Prosave - Siemens SIMATIC HMI KTP400 Basic Operating Instructions Manual

6.7.3

Updating the operating system using ProSave

Requirement
● The HMI device is connected to a PC on which ProSave is installed.
● The data channel parameters are assigned on the HMI device.
Procedure
1. From the Windows start menu, start ProSave on the PC.
2. Select the HMI device type in the "General" tab.
3. Select the type of connection between the HMI device and the PC.
4. Set the connection parameters.
5. Select the "OS-Update" tab.
6. Select the HMI device image file (file type "*.fwf") under "Image path".
The HMI device image files are available under
"Programs\Siemens\Automation\Portal V<TIA version>\Data\Hmi\Transfer\
<TIA version>\Images".
The output area provides information on the version of the successfully opened HMI
device image file.
7. Switch to "Transfer" mode on the HMI device.
If automatic transfer mode is enabled on the HMI device, the device automatically sets
Transfer mode when an update is initiated.
8. Select "Update OS" on the PC to run the operating system update.
9. Follow the instructions in ProSave.
A progress bar indicates the progress of the operating system update.
A message is displayed when the operating system update is successfully completed and
the HMI device is restarted.
Result
The transferred image is available on the HMI device.
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
6.7 Updating the operating system - Basic Panel with PROFINET interface
Commissioning a project
87