Preface - Siemens SIMATIC HMI KTP400 Basic Operating Instructions Manual

Preface

Purpose of the operating instructions
These operating instructions provide information based on the requirements defined by
IEC 62079 for documentation. This information relates to the HMI device, its storage,
transportation, place of use, installation, use and maintenance.
These operating instructions are intended for a variety of target groups. The following table
shows the chapters of these operating instructions that are of particular importance for the
respective target group.
Target group
All
Operators
The operator operates and monitors the system during
the process control phase.
Commissioning engineers
The commissioning engineer integrates the HMI device
into the system and ensures the operating capability of
the HMI device for the process control phase.
Service technicians
Service technicians rectify faults that occur during the
process control phase.
Maintenance technicians
Maintenance technicians carry out servicing and
maintenance work during the process control phase.
The information system of WinCC contains additional information. The information system is
integrated as online help in WinCC and contains instructions, examples and reference
information in electronic form.
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
Chapter
"Safety instructions"
"Overview"
"Operating the device"
All chapters.
Depending on the use of the HMI device,
certain chapters may not be of relevance to
the commissioning engineer, e.g. the
section "Maintenance and servicing."
All chapters.
Depending on the use of the HMI device,
certain chapters may not be of relevance to
the service technicians, e.g. the section
"Maintenance and servicing."
Maintenance and care
3