Table of Contents
Advertisement
Chapter 10 Other Convenient Functions
•
Terminating Transmission of the MIDI
Controller No. 7
1.
Press [SYSTEM] to enter System mode.
2. Press [PARAMETER] to select "VOL SEND SW.''
,- LI
C
::, _, .::J
UOL SEt·m 51.1.I
3. Turn [V ALUEJ to select "Off."
4. Press [PLAY] to return to Play mode.
On
*
This is a system-wide setting, and not a patch setting, so there
is no need to perform a patch write operation. The setting is
a11to111atically stored
i11
memory even after the power is
switched off
TI1is stops the transmission of Control Change No. 7 from
MIDI OUT, eliminating the problem described above.
* This also terminates transmission of Control Change No.
7
messages for other volume-related control, so this setting
slzauld not w;ed exce11t wizen necessary. Please note that once
transmission has /Jeen disa/Jled, it re111ai11s so wrtil you switch
the setti11g /Jack to "On" or restore system-related settings to
their default values by performing a Factory Reset (p. 16).
Terminating Transmission of the Bend Range Request Message
The GR-33 informs any external MIDI device of the GR-33's
current Bend Range setting each time a new patch is selected.
The messages used here are MlDI RPN (Registered
Parameter Number) "Pitch Bend Sensitivity" messages-that
is, Control Change messages No. 100, No. 101, No. 6, and No.
38.
If it is necessary for some reason to stop the transmission of
these messages-such as when you wish to reduce the
number of messages sent to a sequencer as you change
patches on the GR-33-follow the steps below to tum off this
function.
1. Press [SYSTEM] to enter System mode.
2. Press [PARAMETER] to select "BEND REQ SW.''
ISYSI
E:Et-m f<:EG! 51.t.1
On
3. Turn [VALUE] to select "Off."
4. Press [PLAY] to return to Play mode.
• This is a system-wide setting, and not a patch setting, so 1/zere
is no need
to
perform a Patch Write operation. Tire setting is
automatically stored in memory, even after tlze power is
switclzcd off
Once you've done this, no Bend Range Request messages
(MIDI Pitch Bend Sensitivity) are sent when changing
patches.
*
Please 11ote that 011cc tmnsmission has /Jeen disa/J/ed, it
remains so until you return tlzc setti11g ta "On" or restore
system-related settings ta tlrl'ir defilult values by performing a
Factory Reset (p. 16).
98
Advertisement
Table of Contents
