Table of Contents
Advertisement
Chapter 2 Selecting and Playing Sounds (Patches)
3.
While pressing [Sl] on the GK-2A, step on [BANK&]
(pedal
4)
or [BANK
Tl
(pedal
3).
As long as the
[S1]
button is held down, pedal 4 works as
a [BANK&] (BANK UP), and pedal
3
as a [BANK
T)
(BANK DOWN). TI1e display starts to flash, and when
you step on pedal 3 or 4, numbers for the bank digit (the
middle number in the display) go down or up.
~R2~
~R.7:11' " '
4. After selecting the desired group/bank, release [Sl],
then step on the pedals.
When you press a pedal, the patch will be finalized, and
the sow1d will change.
Selecting with the Dial
If you wish to use the dial to select patches, you must make
the following setting for the dial.
1. Press [SYSTEM] to enter System mode.
2. Press [PARAMETER] to select "DIAL FUNCTION."
C LIC
.=, _, _,
Dit=IL FUt·K:Tiot-~
F't=ITCH 8: UALUE
3.
Use [VALUE] to select "PATCH&VALUE."
• PATCH&VALUE:
The dial can be used both for selecting the patch number
and for modifying values while editing.
• VALUE Only:
The dial can be used only for modifying values while
editing.
4. After making the setting, press [PLAY] to return to Play
mode.
In Play mode, you can rotate the [VALUE] dial to select
all 256 patches Al 1-H84.
You can also use [BANK/PARAMETER] to move
forward/backward through the banks.
Using the Base Module plus an
External Foot Switch to Select Patches
By plugging a foot switch into the BANK SHIFf jack on the
rear panel, you can switch banks without pressing [S1] on the
GK-2A.
With one DP-5 (sold separately) to rise through patch bank
numbers, or with two Boss FS-SU foot switches and a branch
cable (sold separately) to move both up and down through
the patch banks, it's possible to perform this procedure using
only your feet.
BANK
SHIFT
PCS-31
Red
BANK
DOWN
White
•
BANK
UP
23
I
Advertisement
Table of Contents
