Roland GR-33 Owner's Manual page 66

I
Chapter 6 Using the Built-in Effects
FINE B (Fine pitch B)
~
100-+ 100
Adjust the pitch shift amount in 2-cent units (1 cent
=
1
i
100th of a semitone) for pitch shift B.
PRE DELAY A (Pre delay time A) 0.0-500 ms
Specify the time delay from the original sound until the pitch
shift A sow1d is heard.
PRE DELAY B (Pre delay time B) 0.0-500 ms
Specify the time delay from the original sound until the pitch
shift B sound is heard.
PAN A (Output pan A) L64-0-R63
Specify the stereo location of the pitch shift A sound.
A setting of
L64
is far left, 0 is center, and
R63
is far right.
PAN B (Output pan B) L64-0-R63
Specify the stereo location of the pitch shift B sound.
A setting of
L64
is far left, 0 is center, and
R63
is far right.
LVL BALANCE (Level balance) Al00:0B-A0:100B
Adjust the volume balance between the pitch shift A and
pitch shift B sow1ds.
With a setting of A 100:0B only the pitch shift A sound will be
output, and with a setting of A0:100B only the pitch shift D
sound will be output.
BALANCE (Effect balance) D 100:0E-DO: 1 00E
Adjust the volume balance between the original sound and
the pitch shift sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of O0:lO0E only the pitch shift
sound will be output.
LEVEL (Output level) 0-127
Specify the output volume.
66
23: FB-P.SFT (Feedback pitch shifter}
This is a pitch shifter that is able to return the pitch shifted
sotmd back to the input.
Lout
Rout
MODE (Pitch shifter mode) 1-5
Higher settings will cause the response to be slower, but the
pitch will be steadier.
COARSE (Coarse pitch) -24-+ 12 #
Specify the pitch shift amow1t in semitone steps. (-2-+1 octave)
FINE (Fine pitch) -100-+ 100
Adjust the pitch shift amount in 2-cent steps
(1
cent= 1
i
100th of a semitone).
PRE DELAY (Pre delay time) 0.0-500 ms
Specify the time delay from the original sound until the pitch
shift sound is heard.
FEEDBACK -98-+98 %
Specify the proportion(%) of the pitch shift sound thnt is to
be returned to the input.
Positive(+) settings will return the sound to the input with
the original phase, wl1ile negative(-) settings produce an
inverted phase.
PAN (Output pan) L64-0-R63
Specify the stereo location of the pitch shift sow1d.
A setting of
L64
is far left, 0 is center, and
R63
is far right.
LOW GAIN ·15-+15 dB
Specify the gain (amount of boost or cut) of the low
frequency range.
Positive(+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN -15-+ 1 5 dB
Specify the gain (amount of boost or cut) of the high
frequency range.
Positive(+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) Dl00:0E-D0:l00E
Specify the volume balance between the original sound and
the pitch shift sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:lO0E only the pitch shift
sow1d will be output.
LEVEL (Output level) 0-127
Specify the output volume.