Motorola MOTORIZR Z6 Service Manual page 37

Level 1 and 2 Service Manual
6809506A96-O
4. Rotate the slider inner assembly upward, to expose the keypad flex connector
which is still attached to the slider outer assembly.
Slider
"mag" assembly
Figure 26. Removing the Keypad Flex Connector
5. Use the disassembly tool to unseat the keypad flex connector. Ensure the
electrical components around the connector are not damaged.
6. Remove the slider front housing from the slider "mag" assembly.
7. To replace, align the slider front housing to the slider "mag" assembly.
8. Insert the keypad end of the slider front housing to the slider mag assembly.
9. Connect the keypad flex connector to the slider "mag" assembly.
10. Lower the top end of the slider inner assembly onto the slider "mag" assembly.
11. Insert and tighten the 2 T5 slider assembly screws. Tighten screws to 1.1 +/-
0.1 in-lbf. Do not overtighten.
12. Replace the front housing, transceiver board assembly, daughter board
assembly, rear housing, SIM, battery, and battery as described in the
procedures.
March 13, 2007
Disassembly
Keypad flex
connector
061771a
37