Table of Contents
Advertisement
26
RackSwitch G8264T: Installation Guide
To mount the RackSwitch G8264T into a System x 4-post rack, complete the
following steps:
1. Use M4 screws to attach the front mounting brackets to each side of the switch.
Torque the screws to approximately 1.13 newton-meters (10 inch-pounds).
9
2. M6 screws, washers, and clip nuts are used to connect the front mounting
brackets to the front and rear posts in the rack. Torque the screws to
approximately 3.5 newton-meters (30 inch-pounds).
4
2
9
1
7
6
Advertisement
Table of Contents
