How To Configure A Serial Port Internet Connection - NETGEAR FWG114P Reference Manual

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
Note: After you finish setting up your router, you will no longer need to launch the ISP's login
program on your PC in order to access the Internet. When you start an Internet application,
your router will automatically log you in.
Select you Internet service provisory from the drop-down list.
a.
The screen will change according to the ISP settings requirements of the ISP you select.
b.
Fill in the parameters for your ISP according to the Wizard-detected procedures starting on
c.
page 3-8.
Click Apply to save your settings.
d.

How to Configure a Serial Port Internet Connection

Use the procedure below to configure an Internet connection via the serial port of your FWG114P.
There are three steps to configuring the serial port of your firewall for an Internet connection:
Connect the firewall to your ISDN or dial-up analog modem
1.
Configure the firewall
2.
Connect to the Internet
3.
Follow the steps below to configure a serial port Internet connection on your firewall.
Connect the FWG114P to your ISDN or dial-up modem
1.
Turn off your Modem and connect the cable (C) from the serial port your FWG114P to the
a.
modem.
MODEM
ISDN or analog modem
Figure 3-11: Connect the ISDN or analog modem to the firewall
Connecting the FWG114P to the Internet
LO CA L
USB
10/100M
4 3 2 1
IN TER N ET
12VDC, 1.0A
C
FWG114P
M-10177-01
3-13