Manually Configuring An Ip Slas Cfm Probe Or Jitter Operation - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 75 Configuring Ethernet OAM and CFM

Manually Configuring an IP SLAs CFM Probe or Jitter Operation

To manually configure an IP SLAs Ethernet echo (ping) or jitter operation, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# ip sla operation-number
Step 3
Switch(config-ip-sla)# ethernet echo mpid
identifier domain domain-name vlan vlan-id
or
ethernet jitter mpid identifier domain
domain-name vlan vlan-id [interval
interpacket-interval] [num-frames number-of
frames transmitted]
Step 4
Switch(config-ip-sla-ethernet-monitor)# cos
cos-value
Step 5
Switch(config-ip-sla-ethernet-monitor)#
frequency seconds
Step 6
Switch(config-ip-sla-ethernet-monitor)#
history history-parameter
Step 7
Switch(config-ip-sla-ethernet-monitor)# owner
owner-id
Step 8
Switch(config-ip-sla-ethernet-monitor)#
request-data-size bytes
Step 9
Switch(config-ip-sla-ethernet-monitor)# tag
text
Step 10
Switch(config-ip-sla-ethernet-monitor)#
threshold milliseconds
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Purpose
Enters global configuration mode.
Creates an IP SLAs operation, and enters IP SLAs
configuration mode.
Configures the IP SLAs operation as an echo (ping) or jitter
operation, and enter IP SLAs Ethernet echo configuration
mode.
Enter echo for a ping operation or jitter for a jitter
•
operation.
For mpid identifier, enter a maintenance endpoint
•
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to 8191.
• For domain domain-name, enter the CFM domain
name.
For vlan vlan-id, the VLAN range is from 1 to 4095.
•
• (Optional—for jitter only) Enter the interval between
sending of jitter packets.
(Optional—for jitter only) Enter the num-frames and
•
the number of frames to be sent.
(Optional) Sets a class of service value for the operation.
Before configuring the cos parameter on the switch, you
must globally enable QoS by entering the mls qos global
configuration command.
(Optional) Sets the rate at which the IP SLAs operation
repeats. The range is from 1 to 604800 seconds; the default
is 60 seconds.
(Optional) Specifies parameters for gathering statistical
history information for the IP SLAs operation.
(Optional) Configures the SNMP owner of the IP SLAs
operation.
(Optional) Specifies the protocol data size for an IP SLAs
request packet. The range is from 0 to the maximum size
allowed by the protocol being used; the default is 66 bytes.
(Optional) Creates user-specified identifier for an IP SLAs
operation.
(Optional) Specifies the upper threshold value in
milliseconds (ms) for calculating network monitoring
statistics. The range is 0 to 2147483647; the default is
5000.
Configuring Ethernet CFM
75-19