Table of Contents
Advertisement
E. ACTIVE ARMING – LOCK & ARM:
1. Press the
button on the transmitter.
2. The siren will chirp once and parking light will flash once indicating that the system is now armed. The
vehicle door will lock upon arming when interfaced with the security system.
AJAR WARNING: If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
SILENT ARMING: Spin up the
transmitter
and
arm confirmation will be through the vehicles parking lights only.
SENSOR BY-PASS:
Bypass The Zone 4: Spin up the
then press the button
two times within 3 seconds. This will arm the security system and
by-pass the zone 4-shock sensor.
The system will chirp one additional time to confirm the sensor bypass mode was
activated. The sensor bypass feature is programmed to activate for one arming cycle
only. The security system will return to normal operation during the next arming
cycle.
HIDDEN ALARM FUNCTION (Silent Alarm): Spin up the
and then press the "Hidden Alarm" button or press the
seconds press the
system will arm and with "Hidden Alarm Function" The siren / horn will be silenced
even if the unit is triggered in the armed status. Notification will only be through the
hand held two-way remote.
F. PASSIVE ARMING (Programming Required)
Active arming / disarming is controlling your security system via the remote transmitter. This security
system is equipped with an optional Passive Arming feature which allows the security system to arm 30
seconds after the last door is closed. Operation is as follows.
1. Turn the ignition to the "OFF" position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you reopen any
door / hood / trunk, the security system LED will stop flashing. It will begin flashing again once the
vehicle all entrances are closed.
3. After 30-second timer has elapsed, the security system will automatically "ARM". The siren will chirp [1]
time and the parking lights will flash [1] time.
PASSIVE ARMING WITH PASSIVE DOOR LOCKING:
The vehicle doors will automatically lock after passive arming cycle has been completed.
PASSIVE ARMING BY-PASS: While the system disarmed, Press the
respond with [1] chirp and LED will turn "ON". The security system will remain in this temporary state for
as long as you wish. To exit passive by-pass, press the transmitter
return to normal status.
G. ACTIVE DISARMING – UNLOCK & DISARM:
1. Press
button on the transmitter.
2. The siren will chirp twice and parking light flash twice to indicating that the security system is now
disarmed. The vehicle's door will unlock and dome light turns on for 30 seconds upon disarming when
interfaced with the security system.
RS1000 OP 1/07
switch to the page
buttons at the same time to arm your security system, No chirp sound will be heard,
switch to the page
or press the
button on the transmitter
1
button to activate the hidden alarm function. The security
and then press the "Silent Arm" button or press the
1
and
2
switch to the page 1
button first; within 3
or
13
button twice, the security will
button and the system will
Advertisement
Table of Contents
