Table of Contents
Advertisement
Basic Operation
Using the [TAP/CTL] Switch to Control the Reverb
With the initial settings, the [TAP/CTL] switch holds the reverb sound (HOLD); however, you can
change this assignment so that the switch varies the way in which reverb is applied.
1
Press the [EDIT] button.
Use the [ H ] [ I ] buttons to select "CONTROL" and then press the
2
[EDIT] button.
3
Use the [ H ] [ I ] buttons to select a parameter, and use the [TIME/
VALUE] knob to edit the value.
Parameter
TAP/CTL
TAP/CTL MODE (*1)
HOLD TIME (*2)
RISE TIME (*3)
FALL TIME (*3)
TAP/CTL PREF
*1: This is shown if TAP/CTL is set to "HOLD, " "TWIST, " or "WARP. "
*2: This is shown if TAP/CTL is set to "HOLD. "
*3: This is shown if TAP/CTL is set to "TWIST. "
TAP/CTL Settings
Value
OFF
HOLD
WARP
TWIST
TAP
MOMENT
FADE
BANK UP
BANK DOWN
4
Press the [EXIT] button to return to the top screen.
8
Value
Explanation
Specifies the function of the [TAP/CTL] switch.
The switch is normally off (minimum value), and turns on (maximum value) only while you
MOMENT
hold it down.
The switch alternately switches off (minimum value) and on (maximum value) each time
TOGGLE
you press it.
0–100
Specifies the time over which the input sound plays back repeatedly.
0–100
Specifies the time over which the twist effect rises.
0–100
Specifies the time over which the twist effect falls.
PATCH
Different settings can be made for each patch.
SYSTEM
The same settings are shared by all patches.
Explanation
No assignment.
The input sound plays back repeatedly while you hold down the switch.
Simultaneously controls the reverb sound's feedback level and volume to produce a totally unreal reverb.
A new type of reverb that produces an aggressive, spinning sensation.
Lets you specify the delay time by tap input.
Outputs the reverb sound only while you hold down the switch.
Fades-in/-out the input sound.
Change banks.
Advertisement
Table of Contents
