Table of Contents
Advertisement
Using Two Patches Simultaneously (Simul Mode)
If FSW MODE is set to "A/B SIMUL, " you can use two patches A and B simultaneously (simul mode).
1
Set FSW MODE to "A/B SIMUL" (p. 20).
2
Press the unlit [A] or [B] switch to make them both light.
Now you can use two patches simultaneously.
MEMO
5 The patch that's selected in the screen (selected by the [ I ] [ H ] buttons) is the patch that
your editing will affect.
5 The TAP/CTL (p. 8) and external footswitch setting (p. 22) apply to both patches A and B.
The lit/blinking state of the [TAP/CTL] switch follows the setting of the patch that's selected
in the screen.
Simul mode settings (BANK)
Here's how to specify how patches A and B are connected and output when in simul mode.
1
Press the [EDIT] button.
2
Use the [ H ] [ I ] buttons to select "BANK," and then press the [EDIT]
button.
3
Use the [ H ] [ I ] buttons to select a parameter, and use the [TIME/
VALUE] knob to edit the value.
Parameter
CONNECTION
OUTPUT MODE (*1)
*1: This is shown if CONNECTION is set to "PARALLEL. "
4
Press the [EXIT] button to return to the top screen.
Value
Explanation
Specifies how patches A and B are connected.
Patches A and B are connected in series, in the order A 0 B.
SERIES
PARALLEL
Patches A and B are connected in parallel.
Specifies how sound is output from the OUTPUT A/MONO and B jacks.
MIX
Patches A and B are mixed and output.
Sound that is input to the INPUT A/MONO jack passes through
patch A and is output to the OUTPUT A/MONO jack.
Sound that is input to the INPUT B jack passes through patch B
A/B
and is output to the OUTPUT B jack.
* If OUTPUT (p. 18) is set to "A:DIR B:EFX, " patches A and B are
mixed and output.
Convenient Functions
Selected patch
21
Advertisement
Table of Contents
