Table of Contents
Advertisement
Parameter List
PATCH
Parameters Common to All Modes
Parameter
Value
REVERB
MODE
Selects the type of reverb (p. 4). The same function as the [MODE] knob.
TIME
0.1–10.0 s (*1)
PRE-DELAY
0–200 ms
EFFECT LEVEL
0–100
LOW (*2)
-50–+50
HIGH (*2)
-50–+50
LOW CUT (*2)
FLAT, 20–800 Hz
HIGH CUT (*2)
630 Hz–16.0 kHz, FLAT
LOW DAMP (*3)
-50–+50
HIGH DAMP (*3)
-50–+50
DENSITY (*4)
1–10 (*5)
MOD DEPTH
0–100
MOD RATE
0–100
*1: If MODE is "EARLY REFLECTION" or "NON-LINEAR (REVERSE), " the range is 0.1–1.0 s.
*2: Except when MODE is "SRV" or "SPACE ECHO"
*3: Except when MODE is "EARLY REFLECTION, " "NON-LINEAR, " "SRV, " or "SPACE ECHO"
*4: Except when MODE is "SFX" or "SPACE ECHO"
*5: If MODE is "SRV, " the range is 0–9.
DELAY
CONNECTION
OFF, SERIES, PARALLEL
TIME
1–2000 ms
Specifies the tempo.
BPM
The range of this setting depends on the TIME or NOTE value.
˜ – ª
NOTE
FEEDBACK
0–100
EFFECT LEVEL
0–120
LOW
-50–+50
HIGH
-50–+50
MOD DEPTH
0–100
MOD RATE
0–100
TEMPO HOLD
OFF, ON
Explanation
Adjusts the length (time) of the reverb sound.
Adjusts the time until when the reverb sound is output.
Adjusts the volume of the reverb sound.
Adjusts the low frequency range tone.
Adjusts the high frequency range tone.
This sets the frequency at which the low cut filter begins to take effect. When
FLAT is selected, the low cut filter will have no effect.
This sets the frequency at which the high cut filter begins to take effect. When
FLAT is selected, the high cut filter will have no effect.
Adjusts the amount of attenuation for the low frequency region.
Adjusts the amount of attenuation for the high frequency region.
Adjusts the density of the reverb sound.
Adjusts the depth to which the reverb sound is modulated.
Adjusts the speed at which the reverb sound is modulated.
Specifies whether reverb and delay are connected in series (SERIES) or in parallel
(PARALLEL). If this is set to "SERIES, " the effects are connected in the order of
delay 0 reverb.
If this is set to "OFF, " the delay is off.
Adjusts the delay time.
Adjusts the delay time. This is specified in terms of a note length relative to the
BPM.
Adjusts the amount of delay sound that is returned to the input.
Higher values produce a larger number of delay repetitions.
Adjusts the volume of the delay sound.
Adjusts the low frequency range tone.
Adjusts the high frequency range tone.
Adjusts the depth to which the delay sound is modulated.
Adjusts the speed at which the delay sound is modulated.
Specifies whether the tempo (BPM) changes or is maintained when you switch
between patches. If the tempo is maintained, the delay time can be maintained.
However, if you switch between patches that have different NOTE settings
( ¸ or ˙ etc.), the delay time will also be different.
11
Advertisement
Table of Contents
