Maintenance And Care - Rinnai RH-S259-SSV-T Operating And Instruction Manual

Disconnect the power supply cord before carrying out
any cleaning or maintenance activities. It is important
to clean and/or replace the filters at appropriate
intervals as grease deposits build-up increases the risk
of fire. Do not operate the extractor hood without
grease filter.
Surfaces:

Wash with warm soapy water and a soft sponge.
Never use abrasive detergent, scouring pads, steel
wool or solvents on any part of this appliance as this
will cause irreparable damage.

If washing by hand, soak the aluminium grease filter
(for ducted models) in warm detergent solution to
simplify the removal of grease. Brush the filter, rinse
thoroughly and leave it to dry before refitting.
If by dishwasher, select an appropriate wash

program. Leave it to dry before refitting. Note: slight
discoloration of the filter may occur.
Removing and inserting the grease filters:

 To remove, depress the handle and pull down at
the same time.
 To refit, slot the filter into position. Make sure that
handle is visible on the outside.
Light replacement
Replace the light bulb with another which has the
same characteristics as a higher voltage bulb could
damage the electrical unit.

Removing and replacing the light bulbs:
Remove oil collector
o
Remove rectifier panel
o
o Remove aluminium charcoal filter/aluminium filter
with charcoal pellets
Remove bottom plate
o
Replace the light bulbs
o
o
Refit bottom plate, filter, rectifier panel and oil
collector.

MAINTENANCE AND CARE

Cleaning the appliance body (Refer to diagram below)
A
B
C
D
E
Charcoal filter (for recirculation models)



6
Remove oil collector
Remove rectifier panel
Remove aluminium grease filter or aluminium grease
filter with charcoal pellets
Remove filter support by removing the 2 screws
Remove the fan blade by removing the self-locking nut
E
The charcoal filters should be replaced when it is
noticeably dirty or discolored, usually after 6 to 12
months depending on the conditions of use.
These filters are not washable and cannot be
restored. To ensure that this appliance functions
effectively, regular maintenance is necessary as
clogged filters restrict airflow and may cause the
motor to overheat.
Removing and inserting the charcoal filter:
Remove the oil collector and rectifier panel.
o
Fit in the new charcoal filter.
o
o Refit rectifier panel and oil collector.
.
You are strongly recommended to follow these safety
instructions. The manufacturer will not be held liable
for any damages to the appliance or any fire hazard
Due to failure to observe the above safety
recommendations.
D
C
B
A