Power Connector And Cable - HP mt20 Maintenance And Service Manual

Power connector and cable

Description
Power connector and cable
Before removing the power cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Service door (see
b. Keyboard (see
c. Top cover (see
d. USB/audio board (see
e. Battery (see
f. Display assembly (see
Remove the power cable:
1. Disconnect the cable from the system board (1).
2. Remove the cable from the clip in the computer (2).
3. Remove the power cable from the computer (3).
Reverse this procedure to install the power cable.
66 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service door on page
Keyboard on page 32)
Top cover on page 39)
USB/audio board on page
Battery on page 50)
Display assembly on page
26).
49)
60)
Spare part number
918201-001