Display Assembly - HP mt20 Maintenance And Service Manual

Display assembly

Description
Display panel assembly, non-touch
Non-touch displays are ONLY spared at the subcomponent level. For more information about display
components, see
This section describes removing components that require you to completely remove the display panel. For
more information about removing display components that do not require that you remove the assembly
from the computer, see
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Service door (see
b. WLAN module (see
c. Keyboard (see
d. Top cover (see
e. USB/audio board (see
f. Battery (see
Remove the display assembly:
1. Position the computer upright on a flat surface.
2. Disconnect the display cable from the system board (1).
3. Pull the wireless antennas through the hole in the computer (2).
4. Remove the 4 Phillips PM2.5×4.0 screws (3) from the display hinges.
60 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Display components on page 17.
Display subcomponents (bezel, webcam, panel) on page
Service door on page
WLAN/Bluetooth combo card on page
Keyboard on page
Top cover on page
USB/audio board on page
Battery on page
26).
32)
39)
49)
50)
Spare part number
not spared
35.
29)