Machine Configuration - Nautilus E916 Service Manual

machine Status
Once you access the Error Log, you can cycle the display through 8 entries by using the up/down keys. Each entry displays
the error label, its position in the log (1-8), and the time (hours) the error occurred. Note that the most recent error might
not be in log position 1—as the number of errors exceeds 8, the newest error will overwrite the oldest. In addition, if a new
error is identical to the log's previous entry, the system checks the time. If the time is the same (within minutes), the error is
not logged, to help prevent redundant errors.
The only way to reset the Error Log is to reconfigure the machine.

Machine Configuration

Use Machine Configuration to change the machine type. The choices are:
• Stepper
• StepMill
• Bike
• Elliptical
In general, only the Elliptical machine type is used for the EV916 or E916.
Refer to the following table to scan through and customize the settings:
Table 2–8. Machine Configuration
Step No. Press Keys
1 ▲, 8, enTeR
2
enTeR
3 ▼ or ▲
4
enTeR
5
CLeAR
NTM Config RQD – resets the machine to a "blank" configuration. The configuration must be set to Elliptical (or other
machine type) for the workout functions to operate.
Stepper CL – configures the machine as a cordless Stepper. Please note that there is a sense line to let the software
know if the system is a Stepper PT (corded); if the system is indeed a Stepper PT, then Stepper PT will appear in the screen
instead of Stepper CL.
18
Display (What you will see)
CHANGE MACHINE
ELLIPTICAL
NTM CONFIG RQD, STEPPER CL, STEPMILL,
ELLIPTICAL, BIKE
Selects your choice
SELECT WORKOUT