Alpine iXE-W400E Owner's Manual page 17

7
Audio Pre-out: Speaker output setting,
ON: Audio output from Pre-out (no output of
host speaker)
OFF: Audio output from host speaker (defaulted)
8
Clock When Standby: Click button 【ON】 to
make digital clock display on the screen while
standby; click button 【OFF】 to make black
screen while standby.
9 Demo Mode: Click button 【ON】 and not hit "OK"
in the attention interface, then it will enter Demo
Mode (default) after 20s; click button 【OFF】 and
no operation in the attention interface, then it will
keep the attention interface after 20s.
HDMI Setting:
10
HDMI IN (defaulted)
DTV IN
Camera Setting: DIRECT IN, RCA IN, and OFF
11
setting, defaults to "DIRECT IN"， only set on/
off, no picture shift.
When selecting DIRECT IN, press the button
on the lower right corner to enter into reversing
setting screen.
Setting:Enter Camera setting screen(only Setting
button available when Camera setting is RCA IN)
Rear:Switch reversing video to visual angle of Rear.
(reversing line on display)
Panorama:Switch reversing video to visual angle
of Panorama. (no reversing line on display)
Corner:Switch reversing video to visual angle of
Corner.
TOP:Switch reversing video to visual angle of TOP.
(no reversing line on display)
11
When selecting RCA IN, press the button
lower right corner to enter camera setting screen.
1) Camera Guide Line: Click the button on the right
side and select 【ON】 to open the adjusting page
of reversing trajectory, and select 【OFF】 to cancel
the adjusting page of reversing trajectory.
2) When you select 【ON】 under Camera Guide
Line, you may hit 【Enter】 on the right of Guide
Line Setting to enter the adjusting page of reversing
trajectory for setting:
B
A
A
Directional button comprising up, down, left, right:
You may operate these four buttons to shift the
reversing trajectory separately or in terms of 5
pixels, and the range of movement is among the
screen borderlines.
B Clockwise, counterclockwise button with respect
to rotation direction: You may operate these two
buttons to rotate the reversing guideline clockwise
or counterclockwise. There are 5 grades available
for your choice, including -3 degree, -1.5 degree,
0 degree, 1.5 degree and 3 degree.
C
Reset: Hit this button to restore the reversing
trajectory to the default location.
Note: The reversing trajectory and the reversing
video footage shall display on the screen simultan-
eously when adjusting is going on.
3) Visual Setting: Click 【Enter】 on the right side
to enter the adjusting page of video picture quality,
see the picture as below:
on
1)
2)
3)
4)
A
B
A
C
A
17-EN