Care And Maintenance; Troubleshooting; Error Indicators; Eliminate Fault - Lumiscope 1146 Instruction Manual

Troubleshooting

Error Indicators

The following symbol will appear on the display when measuring abnormally.
Symbol Cause
Inflation error
Measurement has
failed
Battery power is too
low

Care and Maintenance

Care

Keep the unit in the storage case
when not in use.
Clean the unit with a soft dry cloth.
NOTICE: DO NOT use any abrasive
or volatile cleaners.
NOTICE: DO NOT immerse the unit
or any components in water.
NOTICE: Avoid subjecting the monitor to strong shocks or vibrations, such as
dropping the unit on the floor.
NOTICE: Use the unit in accordance with the instructions provided in this
manual. Use only authorized parts and accessories.
Correction
Wrap the cuff correctly
Inflate again, ensuring cuff is
wrapped correctly
Do not move your arm or body;
remain still and quiet
Measure again, ensuring correct
procedure
Replace both worn batteries with
new ones
29
31
Troubleshooting

Eliminate Fault

Problem
No power
Check the battery installation for proper
Nothing appears on the
placement of both battery polarities
display
Blood pressure varies constantly. Many
factors including stress, time of day, how
you wrap the cuff, etc., may affect your
Measurement values
blood pressure. Review the sections
appear too high or too low
"Proper Measurement Method" and
"Take a Measurement".
Care and Maintenance

Maintenance

Maintenance
NOTICE: DO NOT clean the body or cuff with
solvents, naphtha, thinner or gasoline etc.
gasoline
thinner
NOTICE: Store the unit in a clean,
dry location. DO NOT subject the unit
to extreme hot or cold temperature,
humidity, or direct sunlight.
Causes and Solutions
Replace both worn batteries with new ones
30
NOTICE: DO NOT wet the cuff or
attempt to clean the cuff with water.
NOTICE: Remove the batteries if the
unit will not be used for 3 months or
longer. Always replace both batteries
with new ones at the same time.
+
-
-
+
32