Sharp AL-1611 Service Manual page 19

4) Move the left guide to the appropriate slot as marked on the tray.
• When using 11"×17" copy paper, store the left guide in the slot at the
left front of the paper tray.
5) Load copy paper into the tray.
6) Place the paper size plate in the front of the paper tray.
• The paper size indication which shows through the slot on the front of
the copier should match the selected paper size.
7) Push the paper tray firmly back into the copier.
8) To set the selected paper size, press the PAPER SIZE ENTER
( ) key.
• The selected paper feed location indicator will blink and the corre-
sponding paper size (which is currently set) indicator will light up
steadily. All other indicators except the START (
will go out.
Note: If copying is being performed, paper size setting cannot be made.
9) AL-1622 only Use the TRAY SELECT (
tray of which the paper size has been changed.
• Each time the TRAY SELECT (
be indicated with a blinking paper feed location indicator.
10) Use the ORIGINAL SIZE ENTER (
paper size which is set in the paper tray.
) key indicator
) key to select the paper
) key is pressed, a paper tray will
) key to select the
AL-1611/AL-1622 UNPACKING AND INSTALLATION
• Each time the ORIGINAL SIZE ENTER (
a paper size will be indicated with a paper size indicator.
11) Press the START (
( ) key.
• AL-1622 only To change the paper size setting of the other tray,
repeat steps 9 to 10 after pressing the START (
5 – 4
) key is pressed,
) key and then the PAPER SIZE ENTER
) key.