Sharp AL-1611 Service Manual page 18

13) Store the pressure plate lock which has been removed in step 5 and
the screw which has been removed in step 2 in the front of the
paper tray.
• To store the pressure plate lock, rotate the lock to fix it on the relevant
location.
• For AL-1622, follow steps 3), 4), 13) for both the upper and lower
trays except for storage of the screw.
14) Push the pressure plate down until it locks in place.
15) Squeeze the lock lever of the front guide and slide the front guide to
match the width of the paper.
16) Move the left guide to the appropriate slot as marked on the tray.
• When using A3 copy paper, store the left guide in the slot at the left
front of the paper tray.
Left guide
17) Load copy paper into the tray.
• Set the paper along the guides.
• The tray holds up to 250 sheets of about 9kg bond paper.Do not load
Pressure
plate lock
18) Push the paper tray firmly back into the copier.
19) Ensure that the power switch of the copier is in the OFF position.
• If you use the copier in a country other than the country where the
Screw
20) Plug the other end of the power cord into the nearest outlet.
• Only insert the power cord into a properly grounded wall socket.
4. CHANGING THE COPY PAPER SIZE IN
1) Gently lift and pull out the paper tray until it stops.
2) Push the pressure plate down until it locks in place.
3) Squeeze the lock lever of the front guide and slide the front guide to
Front guide
AL-1611/AL-1622 UNPACKING AND INSTALLATION
5 – 3
paper above the maximum height line.
Maximum height line
Insert the supplied power cord into the power cord socket at the
rear of the copier.
copier was purchased, you will need to make sure that your local
power supply is compatible with your model. If you plug the copier
into an incompatible power supply, irreparable damage to the copier
will result.
Do not use extension cords or power strips.
THE TRAY
match the width of the paper.
Left guide
Front guide