Night Owl XHD Series User Manual page 66

5mp 4/8 channel
Hide thumbs Also See for XHD Series:
Table of Contents

Advertisement

Chapter 10: Troubleshooting
If a problem occurs, you may be able to easily correct it yourself. The following
table describes some common issues and their most likely solutions. Please refer
to the table before calling technical support.
Error
System is not receiving power or
is not powering up.
Hard drive is not detected by
the system.
Hard drive is full (0%) and the
unit is no longer recording.
Mouse not detected by system.
66
Possible Causes
Cable from power adapter is
loose or is unplugged.
Cables are connected, but
system is not receiving sufficient
power.
Hard drive cables are loose or
not properly connected.
There is no hard drive in the
system.
Overwrite is not enabled.
Mouse cable is not firmly
connected to the system.
Mouse is not connected to the
system.
System needs to be reset.
Solutions
1. Confirm that all cables are
connected correctly.
2. Confirm that the power
adapter is securely connected
to the back of the unit.
1. Confirm that the system is
powered ON (LED indicators
on the front should be ON).
2. If the unit is connected
through a power bar or surge
protector, try bypassing the
bar and connecting the power
directly to the wall outlet.
3. Confirm that there is power at
the outlet.
4. Connecting the power cable
to another outlet.
5. Test the outlet with another
plugged device (such as a
phone charger).
Remove the cover and check
that the hard drive cables are
firmly connected.
Open the cover and install a
3.5" SATA hard drive.
Go to the Device Menu > HDD
and ensure that Overwrite is set
to Auto.
Firmly connect the mouse cable
to the USB Mouse port on the
front panel.
Power off the system
(disconnect power cable). Firmly
connect a USB mouse to the
USB Mouse port on the front
panel of the system. Reconnect
the power cable to the DC 19V
port on the real panel.
XHD Series User's Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents