Step 7 Level Refrigerator; Step 8 Alternate Anti-Tip Procedure - Monogram ZPB480D Installation Instructions Manual

STEP 7 LEVEL REFRIGERATOR

All models have 4-point leveling. The front is
supported by leveling legs, and the rear is supported
by adjustable wheels. Both are accessible from
the front of the refrigerator.
• To level the back of the refrigerator, turn the
7/16" hex nut located above the front wheels.
Turn clockwise to raise or counterclockwise to
lower the refrigerator.
• For front leveling, use a 1-1/4" open-end wrench.
• Adjust height of refrigerator to match installation
cutout opening 2121 mm to 2146 mm. The
refrigerator should be level and plumb with cabinetry.
Hex Nut Adjusts
Rear Wheels
CAUTION:
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 25 mm. If
the installation requires more than 2146 mm height,
the installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinetry trim could also be
added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator more
than 25 mm, you will damage the front leveling legs
and the rear leveling wheels.
Installation Instructions
Leveling Leg
13
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent tipping.
The anti-tip brackets cannot be used on metal
wall studs. Use this Alternate Procedure to secure
the refrigerator against tip-over whenever metal
wall studs are encountered and there is no soffit.
Top Case Trim
Install Four
1-1/2" Drywall Screws
Through Trim and Into Soffit
or 19.05 mm Min. Wood Brace
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 19.05 mm min.
wood brace. The brace spanning the enclosure must
be securely fastened to cabinets on both sides.
• Install four, 1-1/2" drywall screws into the pilot holes.
19.05 mm
Min.
Side View
Top Case Trim