Fingerprint Reader Board Cable - HP EliteBook x360 1030 G2 Maintenance And Service Manual

Fingerprint reader board cable

NOTE: The fingerprint reader board spare part kit does not include the fingerprint reader board cable.
The fingerprint reader board cable is included in the Cable Kit, spare part number 917893-001.
Before removing the fingerprint reader board cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. Fan (see
d. Speakers (see
e. System board (see
Remove the fingerprint reader board cable:
1. Release the ZIF connector (1) to which the fingerprint reader board cable is attached, and then
disconnect the fingerprint reader board cable from the fingerprint reader board.
2. Detach the fingerprint reader board cable (2) from the keyboard/top cover. (The fingerprint reader
board cable is attached to the keyboard/top cover with double-sided adhesive.)
3. Remove the fingerprint reader board cable (3).
Reverse this procedure to install the fingerprint reader board cable.
48 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 29)
Solid-state drive on page
Fan on page 34)
Speakers on page 35)
System board on page
27), and then remove the following components:
30)
43)