Konica Minolta BIZHUB 215 Installation Manual page 6

4. Ready a packet of the developer and cut off one
corner of the aluminum packet with scissors.
5. While turning the gear in the direction of the
arrow, pour the developer evenly into the devel-
oper chamber.
Note:
• Turn the magnet roller in the direction of its nor-
mal rotation, and not the backward.
• Be sure not to let the developer get inside the
collar.
6. Reinstall the developing unit cover, ensuring that
its tabs are fitted properly into the slits. (Three
screws)
Note:
Do not tilt the developing unit or imaging unit after
the developer is poured.
Temporarily tighten the screw first.
Collar
A0XXIXC015MA
A0XXIXC016MA
7. Install the front of the drum unit first, and then the
rear part. Then, secure the screws. (Five screws)
Note:
• Do not open the lower part wide, otherwise the
charger may drop.
• Clean the screw groove before securing them.
• Do not touch or scratch the photo conductor.
8. Attach the imaging unit connector that is removed
in step 1.
Temporarily tighten
the screw first.
9. Slide the imaging unit into the machine, and then
secure the screws. (Two screws)
Note:
• Make sure that the right door is open when slid-
ing the imaging unit into the machine.
• Align the shaft of the imaging unit with the guide
of the machine.
E-6
Temporarily tighten
the screw first.
A0XXIXC017MA
A0XXIXC019MA