Konica Minolta BIZHUB 215 Installation Manual page 5

10. Slide out the drawer and remove the developer
and cushioning material.
Developer
11. Slide the drawer back in.
VII. Loading the developer
1. While pressing the connector tabs, push out the
connector from the imaging unit.
Tab
2. Unscrew the screws that secure the drum unit,
and then take out the drum unit by slightly open-
ing the lower part (the shadowed area) of the
drum unit. (Five screws)
Note:
• Do not open the lower part wide, otherwise the
charger may drop.
• Do not touch or scratch the photo conductor.
• Cover the drum unit, which has been removed,
with a protective cloth or similar material.
A3PEIXC012DA
Developing
unit
A0XXIXC040MA
3. Remove the developing unit cover. (Three
screws)
E-5
Drum unit
A0XXIXC013MA
A0XXIXC014MA