Adf And Scanner Components - Ricoh 1000L Field Service Manual

6-2 ADF AND SCANNER
6-2-1 Feed and Pick-up Rollers
1. Remove the document table (see section 6-1-5).
2. Remove the ADF clutch covers (4 screws).
See section 6-2-3.
Remove the rear inner cover (3 screws).
3.
See section 6-1-5.
4. Remove the front inner cover (5 screws).
See section 6-9-1
5. Remove the lower document guide plate (5 screws).
CAUTIONS:
• Put the exposure glass and the two retaining plates in
a safe place.
• Do not lose the leaf spring from on top of the ADF
clutch.
• On reassembly, don't forget to connect the ground
wire to the front exposure glass retaining plate.
6. Take out the pick up/feed roller and shaft assembly (A).
1) Push the roller shaft towards the DSB
2) Remove 2 E-rings
3) Slide the two bushings towards the rollers until they
are free of the pickup bracket (B)
4) Lift out the shaft
7. Take off the paper feed roller (C) and pick-up roller (D)
(1 clip each, 1 belt).
6 - 5