Configuring A Local Device To Authenticate Its Peer In Pap Mode - Huawei Quidway S9300 Configuration Manual - Wan Access

Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access
l
This section describes how to configure unidirectional PAP authentication.
Pre-configuration Tasks
Before configuring PAP authentication, complete the following tasks:
l
l
Data Preparation
To configure PAP authentication, you need the following data.
No.
1
2
2.4.2 Configuring a Local Device to Authenticate Its Peer in PAP
Mode
This section describes how to configure PAP-related parameters for the authenticator. PAP
authentication is a two-way authentication mode, and PAP authentication is implemented only
at the beginning of link establishment.
Context
Do as follows on the switch.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
aaa
The AAA view is displayed.
Step 3 Run:
local-user user-name password { simple | cipher } password
The username and password of the authenticated are added to the local user list.
Step 4 Run:
quit
Issue 02 (2011-07-15)
Bidirectional authentication: Two communication parties function as both the authenticator
and the authenticated.
Connecting interfaces and configuring physical attributes for these interfaces to ensure that
the physical layer of the interfaces is Up
Configuring PPP as the link layer protocol of interfaces
Data
Number of the interface
Username and password of the authenticated
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 PPP Configuration
22