Encapsulating An Interface With Hdlc; Configuring The Ip Address Of The Interface - Huawei Quidway S9300 Configuration Manual - Wan Access

Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access
Applicable Environment
When you need to enable the bits synchronous transmission using the link layer protocol, you
can adopt the HDLC protocol.
Pre-configuration Tasks
Before configuring the basic HDLC functions, configure the physical attributes of the interface
to make the physical status of the interface become Up.
Data Preparation
To configure HDLC, you need the following data.
No.
1
2
3

3.3.2 Encapsulating an Interface with HDLC

The link layer protocol of the interfaces joining an IP-Trunk interface must be HDLC.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
link-protocol hdlc
The interface is configured with HDLC.
By default, the interface is encapsulated with PPP.
----End

3.3.3 Configuring the IP Address of the Interface

You can assign an IP address to an interface.
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HDLC and IP-Trunk Configuration
Data
Number of the interface to be configured with
HDLC
Interface address
(Optional) Polling interval
41