Operation - Dimplex PF2325 Owner's Manual

Hide thumbs Also See for PF2325:
Table of Contents

Advertisement

Operation

General Operation
WARNING: This electric irebox
must be properly installed before it is
used.
This irebox operates with
Comfort$aver
TM
tomatically adjusts the fan speed and
heater wattage to safely and precisely
match the requirements of the room
based on the thermostat setting. The
heater operates such that once the
room reaches the set point, the fan
and heater will continuously run at a
low level, to maintain the desired room
temperature. If the temperature in the
room rises signiicantly, i.e. sun coming
through a window or a central furnace
turns on, the heater and fan will turn
off and periodically turn back on to cir-
culate the air around the unit, until the
room temperature drops and requires
the heater to be constantly on again.
!
NOTE: The unit is designed so that
the fan will run continuously while the
heater is on.
!
NOTE: The element retains heat
after shutdown, there is a built in cool
down period of 1 minute before the
fan shuts off completely.
TM
gWave
Controls
The ireplace can be operated by a
simple "wave" in-front of the unit. By
waving your hand vertically approxi-
mately 4 in. (102 mm) in-front of the
gWave
TM
sensor in the upper right hand
corner of the unit, the unit and different
10
technology, which au-
control functions can be activated. This
is also indicated by the LED light turn-
ing green.
There is a Gesture On/Off button
located below the LED pilot light
which can be used to turn this feature
On or Off (a more detailed description
is located below with the individual
feature options). It is recommended
that a straightened paperclip be used
to press the button through the small
hole. When the gWave
turned off, the green light will lash
4 times before turning off and it will
remain solid green when the gWave
controls are active.
!
NOTE: The unit is programmed to
have a built in demonstration mode to
exhibit all of the functions of the unit in
a 95 second period of time. This can be
activated by holding your hand infront
of the gWave
sensor for 7 seconds.
TM
When the unit has gone through the
demonstration mode once it will return
to the previous operation.
Remote Operation
The ireplace is supplied with an IR
multifunction remote control.
NOTE: To operate correctly,
!
the remote control must be pointed
towards the front of the unit.
Controls
Standby: Turns unit On or Off.
1.
→ Activated by pressing the cor-
responding button on the remote
controls are
TM
TM
www.dimplex.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pf3033

Table of Contents