Dimplex PF2325 Owner's Manual page 13

Operation
using the buttons on the remote the
lighting of the unit can be adjusted
to any shade of any colour. The
initial setting is no light (R=0, B=0,
G=0) and can be adjusted, while the
display is lashing, by pressing the
outlined buttons (below) to adjust the
tones.
•
Red Tones:
decrease.
•
Green Tones:
decrease.
• Blue Tones:
decrease.
NOTE: There are 25 different set-
!
tings for each colour.
Brightness: Changes the
9.
brightness of the lights in the unit.
→ Adjusted by repeatedly press-
ing the corresponding button on
the remote.
• Indicated by the second digit on
the Floating Display™ changing
to show: "A" (high), "b" (low), "C"
(high with media licker) and "d"
(low with media licker).
NOTE: Media licker is not an
!
option on the Multi-Fire XD™ levels
5, 6 or P.
Sleep timer: turns the unit off
10.
after a preset duration (from 30
minutes (0.5h) to 8 hours, in ½
hour increments).
increase and the
increase and
increase and
→ Activated and adjusted by re-
peatedly pressing the correspond-
ing button on the remote.
• Indicated by the Floating
Display™ changing to indicate
30 minutes (0.5 h) through 8
hours. The ireplace will automati-
cally turn off when the sleep timer
reaches zero minutes. The sleep
timer can be cancelled at any time
by pressing the sleep timer button
repeatedly until the sleep timer
will no longer be visible.
11. Numerical Display
→ Default display will be the
heater air intake temperature or
settings (eg. Multifire XD, Bright-
ness, etc.)
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in the
same fashion, with remainder of the
controls.
Pressing the
or disable the heater. When in the
heat disable mode the temperature
reading/setting on the On Screen
Display displays nothing ("--").
!
NOTE: The heat will not work in
manual controls either.
will enable
then
13