Table of Contents
Advertisement
I Drain hose
• Drain hose is flexible and can be routed to suit various
piping arrangements. The drain line must include elbow
trap (U bend). Connect a plastic condensate pipe with
an internal diameter of 12 mm.
Note: Do not put the drain hose end into water.
• The drain hose can be connected to the left or the
right side.
For left and left rear piping (Factory standard)
I Indoor Unit Fixing
• Thread the indoor unit piping and cable through the hole.
• Hang the top of the unit onto the upper ridge of them in mounting plate.
• Make sure that the unit is correctly hung in place by sliding it to the left, then to the right.
• Press the bottom left and bottom right hand corners of the unit against the mounting plate until the fixing prongs click
into place in the retainers provided to that effect.
10
ENGLISH
J222
Drain hose
Drain cap
Drainage line
Interconnection cable
10
For right connection
Drain hose
Drain cap
Verification of condensate water drainage:
Fill the drain pan with water and observe evacuation.
a
Condensate
drainage line
Vinyl tape
Note: The condensate evacuation line should be taped to the re-
frigerant lines with vinyl tape.
24/06/2005, 10:45 AM
a) Access plate for the
condensate drainage
pump detection
(condensate pump is
available as an
accessory).
Advertisement
Table of Contents
