ULX-D Dual and Quad Z16-20
ULX-D
② RF Antenna Diversity Input Jack (2)
For antenna A and antenna B.
③ RF Cascade Jack (2)
Passes the RF signal from Antenna A and Antenna B to one additional receiver.
④ Mic/Line Switch (one per channel)
Applies a 30 dB pad in mic position.
⑤ Balanced XLR Audio Output (one per channel)
Connect to a mic or line level input.
⑥ Network Status LED (Green)
One per network port.
•
Off = no link
•
On = network link
•
Flashing = network link active
⑦ Ethernet/Dante Network Secondary Port
Connect to an Ethernet network to enable remote device control via WWB6 software. Also carries Dante digital audio and control signals for audio distribution,
monitoring, and recording - see Dante Network topic.
⑧ Network Speed LED (Amber)
One per network port.
•
Off = 10/100 Mbps
•
On = 1 Gbps
⑨ Ethernet/Dante Network Primary Port
Connect to an Ethernet network to enable remote device control via WWB6 software. Also carries Dante digital audio and control signals for audio distribution,
monitoring, and recording - see Dante Network topic.
Receiver Home Screen
The home screen displays the following information for each receiver channel:
•
Group and Channel
•
Transmitter Status: NoTx or TxOn, battery icon/remaining battery life
Press the SEL button to access a channel menu screen.
Transmitters
① Power LED
•
Green = unit is powered on
•
Red = low battery or battery error (see Troubleshooting)
•
Amber = power switch is disabled
② On/Off Switch
Powers the unit on or off.
③ SMA Connector
Connection point for RF antenna.
④ LCD Display:
View menu screens and settings. Press any control button to activate the backlight.
⑤ Infrared (IR) Port
Align with the receiver IR port during an IR Sync for automated transmitter programming.
⑥ Menu Navigation Buttons
Use to navigate through parameter menus and change values.
6/45
Digital Wireless Microphone System
1 G:01 CH:01
2 G:01 CH:02
3 G:01 CH:03
4 G:01 CH:04
TxOn
TxOn
TxOn
TxOn
Shure Incorporated
2017/06/09