Setting Receiver Gain - Shure ULX-D Dual Manual

ULX-D Dual and Quad Z16-20 ULX-D
Shure SB900 Runtime
1 mW
>11 hours
Important Tips for Care and Storage of Shure Rechargeable Batteries
Proper care and storage of Shure batteries results in reliable performance and ensures a long lifetime.
• Always store batteries and transmitters at room temperature
• Ideally, batteries should be charged to approximately 40% of capacity for long-term storage
• During storage, check batteries every 6 months and recharge to 40% of capacity as needed
Installing the Battery Contact Cover
Install the included battery contact cover (65A15947) on the handheld transmitter to prevent light reflection in broadcast and performance situations.
1. Align the cover as shown.
2. Slide the cover over the battery contacts until it is flush with the transmitter body.
Note: Slide the cover off before inserting the transmitter in the battery charger.

Setting Receiver Gain

The receiver gain control sets the audio signal level for the entire receiver and transmitter system. Changes to the gain settings occur in realtime allowing for
adjustments during live performances. When adjusting the gain, monitor the audio meter levels to prevent signal overloads.
Receiver Gain Controls
The gain can be adjusted by using the gain ▲▼ buttons or by entering the AUDIO menu and using the control wheel.
Tip: To quickly adjust the gain, press and hold a gain button to enable accelerated scrolling.
Reading the Audio Meter
The audio meter displays yellow, green, and red LEDs to indicate the audio signal level. Audio peaks illuminate the LEDs for 2 seconds, while the RMS signal
is displayed in realtime.
2017/06/09
Digital Wireless Microphone System
10 mW
>11 hours
Shure Incorporated
20 mW
>7 hour
17/45