Self-Diagnostic Test; Counter, Parameter / Maintenace Count - Toshiba B-EX4 Maintenance Manual

5. SYSTEM MODE

5.3 SELF-DIAGNOSTIC TEST

Outline of Self-Diagnostic Test
In the Self-Diagnostic Test mode ,the printer checks and prints out the printer system information such
as the sensor or interface, and the Maintenance Counter. Also it makes the print head broken element
check.
The Self-Diagnostic Test contains the following sub menus:
DIAG. menu item list
MENU ITEM
System Mode / SYSTEM MODE
<1>Diagnostics / <1>DIAG.
Counter, Parameter / MAINTENANCE CONT
Auto Diagnostics / AUTO DIAGNOSTIC
Head broken dot check / HEAD CHECK
5.3.1 Counter, Parameter/ MAINTENANCE COUNT
The MAINTENANCE COUNT print procedure of DIAG. is described.
The menu layer from DIAG. to MAINTENANCE COUNT is below.
MENU ITEM
System Mode / SYSTEM MODE
<1>Diagnostics / <1>DIAG.
Counter, Parameter / MAINTENANCE CONT
If error occur during printing, the error message is displayed, the error LED turns on and the onlineLED
turns off. The erro can be canceled by [ENTER], [CANCEL] or [MODE] key, but printer did not perform
re^printing.
Print method / PRINT TYPE
Thermal transfer / TRANSFR
Direct thermal / DIRECT
Cut type / CUT TYPE
Disable / OFF
Enable / ON
Print/ CHECKING & PRINT
5-3
EO18-33027
5.3 SELF-DIAGNOSTIC TEST