Regular Printing Is Selected, But A Roll Is Loaded; Paper Jam; Paper Is Crooked - Canon iPF670 User Manual

iPF670

Regular printing is selected, but a roll is loaded.

Regular printing is selected, but a roll is loaded.

Cause
A print job for printing on sheets
was sent when a roll is loaded.

Paper jam

Paper jam

Cause
A paper jam oc- For roll paper, cut the paper on the upper side of the {Paper Feed Slot.
curred in the
1.
Push the Release Lever back and remove the jammed paper.
printer during
(See "Clearing Jammed Roll Paper.")
printing.
(See "Clearing a Jammed Sheet.")
2.
Load the paper.
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Printer.")
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK but-
ton.
Printing will resume, starting from the page on which the error occurred.

Paper is crooked.

Paper is crooked.

Paper loaded crooked was detected when the paper was advanced.
•
To disable this message (if it is displayed repeatedly despite reloading paper, for example), choose Off or Loose in
the Skew Check Lv. setting of the printer menu. However, this may cause jams and printing problems because paper
Important
may be askew when printed. Also, the Platen may become soiled, which may soil the back of the next document
when it is printed.
User's Guide
1.
Press ▲ or ▼ to select Remove Roll Paper, and then press the OK button to stop printing.
2.
After removing the roll, load and print on a sheet of the type and size of paper you have specified
in the printer driver.
(See "Removing the Roll from the Printer.")
(See "Loading and Printing on Sheets.")
Press ▲ or ▼ to select Stop Printing, and then press the OK button to stop printing.
P.580
➔
➔
Cause
Corrective Action
P.362
➔
P.21
➔
Corrective Action
P.577
➔
P.357
P.375
➔
Follow these steps to reload the roll.
1.
Push the Release Lever back.
2.
Adjust the right edge of the roll to make it parallel to the orange
Paper Alignment Line.
3.
Pull the Release Lever forward.
(See "Loading Rolls in the Printer.")
If this error recurs after you reload the roll, remove the Roll Holder
from the printer, push the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
Follow these step to reload a sheet.
1.
Push the Release Lever back.
2.
Pull out the sheet.
3.
Pull the Release Lever forward.
4.
Reload the sheet, aligning it with the guide on the right.
(See "Loading Sheets in the Printer.")
Regular printing is selected, but a roll is loaded.
Corrective Action
P.357
➔
P.354
➔
P.375
➔
615