Before Starting The Cut; To Attach A Comb; To Remove The Comb - Remington HC6550 Instructions Manual

ENGLISH
F INSTRUCTIONS FOR USE
• For corded use connect the product to the adaptor, then to the mains.
, Caution: Extended mains only use will result in the reduction of the battery
life.
• Cordless use – when the product is switched on and fully charged it can be
used in cordless mode for up to 60 minutes.
• Switch the product on by sliding up the on/off switch.

, BEFORE STARTING THE CUT

• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
Guide Comb
0 (Grade 0)
1 (Grade 1)
2 (Grade 2)
3 (Grade 3)
4 (Grade 4)
5 (Grade 5)
6
7
8
• Each comb attachment is marked accordingly on its outside middle surface.
• Use the clipper without any fixed combs for trimming hair close to the skin.
• This will trim hair to 1mm, holding the clipper so the blades are
perpendicular to the skin will trim hair to 0.5mm.

, TO ATTACH A COMB

• Hook the front edge of the comb to the front teeth of the wide trimmer
blade. Then push the back of the comb down until it snaps in place.

, TO REMOVE THE COMB

• Push up the back of the comb until it clicks off the clipper blade.
Cutting Length
1.5mm
3mm
6mm
9mm
12mm
16mm
18mm
22mm
25mm
5