Page 12
One of three sets of displays will be shown depending on what was selected in Configuration Settings Step 4CS.
EXIT TO
DISPLAY
SCREENS
28 Day or 28/Volume (Gallons) selected in Configuration Settings Step 4CS
EXIT TO
DISPLAY
SCREENS
Installer Display Settings
Volume (Gallons) selected in Configuration Settings Step 4CS
Step 1I - To enter Installer Display press the NEXT and buttons simultaneously for
Step 1I
5 seconds and release.
Step 2I - Volumetric capacity in gallons to regeneration.
Step 2I
Press NEXT to go to Step 3I or if Soft was selected in Step
2CT and rES was selected in step 5CS the next display will
require entry of the grains of hardness as calcium carbonate
per gallon using or . Default is 20 with value ranges from 1 to 150 grains. Note:
The grains per gallon can be increased if soluble iron needs to be reduced. Press
NEXT after hardness is selected to go to Step 3I.
Press REGEN to exit Installer Display.
Step 3I
Step 3I - Adjust day override from 1 - 28 or OFF. Press NEXT to go to Step 4I. Press
REGEN to return to previous step.
Step 4I
Step 4I - Use or to set the regen hour.
Press NEXT to go to Step 5I. Press REGEN to return to the previous step.
Step 5I - Use or to set the regen minutes. Press NEXT to exit Installer Display.
Step 5I
Press REGEN to return to previous step.
Step 1I
Step 2I
Step 3I
Step 4I
Step 1I -
To enter Installer Display press the NEXT and
buttons simultaneously for five seconds and release.
Step 2I -
Adjust days from 1 - 28. Press NEXT to go to
Step 3I. Press REGEN to exit Installer Display.
Step 3I -
Use or to set time of the regen hour. Press
NEXT to go to Step 4I. Press REGEN to return to previous
step.
Step 4I -
Use and to set the regen minutes. Press
NEXT to exit Installer Display. Press REGEN to return to
previous step.
SD Manual