Network: Advanced
Email Settings:
This section has been covered in the quick start guide.
WiFi Settings:
This section has been covered in the quick start guide.
Server Port:
This is the port that the device will use to send information
through. You'll need to enable UPnP on your router so your router can
selectively open these ports, allowing the device to communicate via the
Internet.
HTTP Port:
This is the port through which you will be able to log in to
the device.
UPnP Enable:
This is enabled by default.
Tap APPLY to save settings.
Many of the following networking settings are not required when using SwannLink P2P for remote access.
8