Test Procedures; Initial Functional Check For 8.2 Rf Test; Philips 330 - Philips 330 Service Manual

you can disconnect the charger. Remove the connector by pressing the release button on top of the connector.
Depart. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
8.0

TEST PROCEDURES

8.1 Initial Functional check for PHILIPS 330
8.1.1 Insert the Test Production Card into the SIM reader at the back of the mobile phone and clip a charged
battery on the phone.
8.1.2 Press the "ON" button for 2 seconds at least and the LCD will show a message, which contains information
of FA (Final Adjustment) status and 12NC.
8.1.3 Follow the instructions as mentioned below:
Step
1
2
3
4
5
 PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
Procedure
Press Key 1
Press Key 1 again.
Press key 2
Press key 2 again
Press key 3
(Audio loop local effect)
Press key 3 again
Press key 4
Press key 4 again
Press Key 5
(Checkerboard test) &
Backlight activation
Press Key 5 again
Service Repair Support
Observation
MANUAL TEST
GOOD
Left corner displays
BUZZER
TEST
Left corner displays
"LocalEffect"
" xx xx xx xx "
" xx xx "
Left corner displays
"KEY WITHOUT TEST"
Left corner displays
Checkerboard 1, 2 & 3 pixel on
Left corner displays
COMPANY RESTRICTED
VY-V-640-P330
Page : 12 of 43
Langue : EN
Date : 11/06/03
1 MANUAL
00 AUTOTEST
00 KBD RAM
2 MANUAL
01 AUTOTEST
00 KBD RAM
3 MANUAL
02 AUTOTEST
00 KBD RAM
4 MANUAL
03 AUTOTEST
00 KBD RAM
5 MANUAL
04 AUTOTEST
00 KBD RAM
VY-V-640-P330