Philips 330 Service Manual page 38

Depart. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
9.2.11 Vibrator positioning
- Insert the vibrator in its place.
- Check the SIM holder fonctionnality
Vibrator
9.2.12 Rear Housing inserting
1 - Connect the vibrator. It does not exist polarisation on it.
2 - Put the rear housing on the board.
3 - Take care to put wire out of the screw crossing.
1 - Vibrator
connection
4 - Clip the rear on the front.
5 - Push on it, on all the outside parts.
6 - Screw the 4 screws on the flip looking out the autoforming.
- With specific screw driver, turn the screw to the left to find the thread.
- After that you have to screw to the right and stop when it's little bit more difficult.
 PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
Service Repair Support
0.1N/m
COMPANY RESTRICTED
SIM holder
4
4
VY-V-640-P330
VY-V-640-P330
Page : 38 of 43
Langue : EN
Date : 11/06/03