Samsung VP-L900 Training Manual page 67

Alignment and Adjustments
5-5-3 Adjustment
1. Kinds of adjustment in PLAY mode.
2. Adjustment
* Please keep the order according to explanation.
2-1. Setting of the model code0
a. Preparation
Table. 5-6
TAPE NONE
EQUIPMENT POWER SOURCE
OTHER NONE
TEST POINT NONE
ADDRESS 063
NAME MODEL CODE0
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the "BLC(MODE UP)" or
"FADE(MODE DOWN)" button of Camcorder so
as to select the address 063.
e. Press the "DSE(DATA DOWN)/P.AE(DATA UP)"
so that OSD shows" "ERR:XX EVR: XX" "XX" is
different dependent on the model as below.
MODEL NAME
VP-L900
PAL VP-L906
VP-L907
f. Be sure to press the "ENTER(CONFIRM)"
button on Camcorder to memorize setting.
g. Reset the power source so as to fix the new data to
the Camcorder's EEPROM
5-16
ADDRESS
HD SWP
061
32. 768 KHZ CLOCK
062
MODEL CODE
063
D.ZOOM SIZE
064
TBC DEFAULT
065
Table. 5-7
ADDRESSED CODE
64
7F
7F
Table. 5-5
NAME
NTSC
2-2. Head Switching Point
: This adjustment is performed after the replace-
ment of deck mechanism.
• Without this adjustment, there will be a noise in
playback picture.
a. Preparations
TAPE
EQUIPMENT
OTHER
TEST POINT
ADDRESS
NAME
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the "BLC(MODE UP)" or "FADE(MODE
DOWN)" button of Camcorder so as to select the
address 061.
e. Insert the Standard Color Bar Tape and press the
"PLAY" button.
Note : If there is no video out, when you pressed the
"PLAY" button, you can not adjust the Head
Switching Point.
It may be caused by maladjusted VIDEO
block.
In this case, adjust the VIDEO block before
the Head Switching Point.
MODEL
PAL
Adjustment
1C
Model code setting
88
05
01
Table. 5-8
STANDARD COLOR BAR TAPE RECORDED
WITH SP SPEED
*NTSC
POWER SOURCE
NONE
NONE
061
HD SWP
Samsung Electronics