Samsung VP-L900 Training Manual page 59

Alignment and Adjustments
9. B-Y Gain
1) Camera "E-E", 3100°K color bar chart.
2) Video(output) jack and register of EEPROM.
3) Connect video(output) jack to waveform monitor
input jack and monitor TV jack respectively.
4) Press the "BLC(MODE UP)/FADE(MODE
DOWN)" button so that the OSD state is "283. XX
XX(High)""284. XX XX(Low)".
5) Aim the camera at a color bar chart illuminated at
1500 to 2000 lx.
6) Adjust the "P.AE(DATA UP)/DSE(DATA DOWN)"
button so that the blue level is
50IRE, PAL : 350mV
7) Be sure to press the "ENTER(CONFIRM)" button to
memorize setting.
Note : Bright dot shifts after the confirm button is
pressed.
(outdoor : 036, 037)
Fig. 5-11
10. R-Mg Hue
1) Camera "E-E", 3100°K color bar chart.
2) Video(output) jack and register of EEPROM.
3) Connect video(output) jack to vectorscope input
jack and monitor TV jack respectively.
4) Press the "BLC(MODE UP)/FADE(MODE
DOWN)" button so that the OSD state is "284. XX
XX(High)""285. XX XX(Low)".
5) Aim the camera at a color bar chart illuminated at
1500 to 2000 lx.
6) Adjust the "P.AE(DATA UP)/ DSE(DATA DOWN)"
button so that theRed vector is 105.
7) Be sure to press the "ENTER (CONFIRM)" button
to memorize setting.
Note : Bright dot shifts after the confirm button is
pressed.
(outdoor : 038, 039)
5-8
NTSC :
11. G-Cy Hue
1) Camera "E-E", 3100°K color bar chart.
2) Video(output) jack and register of EEPROM.
3) Connect video(output) jack to vectorscope input
4) Press the "BLC(MODE UP)/FADE(MODE
5) Aim the camera at a color bar chart illuminated at
50 IRE (NTSC)
350mV (PAL)
6) Adjust the "P.AE(DATA UP)/ DSE(DATA DOWN)"
7) Be sure to press the "ENTER (CONFIRM)" button
Note : Bright dot shifts after the confirm button is
RED VECTOR
105 DEG.
Fig. 5-12
jack and monitor TV jack respectively.
DOWN)" button so that the OSD state is "286. XX
XX(High)""287. XX XX(Low)".
1500 to 2000 lx.
button so that the Cyan vector is 284.
to memorize setting.
pressed.
(outdoor : 03A, 03B)
Fig. 5-13
CYAN VECTOR
284 DEG.
Samsung Electronics