Product Does Not Appear In Mac Printer Window; Cannot Print Over A Network - Epson XP-446 User Manual

Related topics
Wi-Fi Networking

Product Does Not Appear in Mac Printer Window

If your product does not appear in the Mac printer window, try these solutions:
• Turn your product off, wait 30 seconds, then turn it back on again.
• If you are connecting the product wirelessly via EpsonNet Setup and a WiFi symbol is not displayed on
the product's LCD screen, make sure your product software was installed correctly. If necessary,
reinstall your software.
• Make sure you installed your product software correctly for your network. See the Start Here sheet for
instructions.
• If your Mac includes both wired and wireless network services, make sure the network to which you
connected your product is at the top of the Set Service Order list. Check your Mac documentation for
instructions.
Note: If you are using a 5 GHz wireless router, set the router to operate in dual band (2.4 GHz and
5 GHz) mode. If your router uses a single network name (SSID) for both the 2.4 GHz and 5 GHz band,
give each band its own network name (SSID) instead, such as Home Network 2.4 GHz and Home
Network 5 GHz. See your router documentation or contact your internet service provider for
instructions.
Parent topic:
Related concepts
Uninstall Your Product Software
Related topics
Wi-Fi Networking

Cannot Print Over a Network

If you cannot print over a network, try these solutions:
• Make sure that your product is turned on.
• Make sure you install your product's network software as described in your product documentation.
• Print a network status sheet and verify that the network settings are correct. If the network status is
Disconnected, check any cable connections and turn your product off and then on again.
Solving Network Problems
203