Table of Contents
Advertisement
Internet and PC Link
C) Wired home network with a
router
Follow these instructions if you have a home network with
a router and broadband Internet access.
router
Connect ETHERNET on the Streamium System to a
1
LAN port of your router with the supplied ethernet cable.
Press INTERNET on the remote control.
2
If the Streamium System connects to the Internet you will
be asked to register with "My.Philips.com. " Continue with
chapter "Registration. "
If the Streamium System does not connect to the
Internet
The Streamium System may not connect to the Internet
because
– a connection error has occurred. Press INTERNET again
to reconnect.
– the router is not connected to the Internet. Check if the
computers connected to the router have access to the
Internet.
– the IP settings are not correct. Continue with "If 'An IP
address could not be obtained automatically.Would you
like to enter your network settings manually?' appears. "
– your Internet service provider is using a proxy. Continue
with "If 'The system could not connect to the server.'
appears. "
24 Please visit http://My.Philips.com
broadband internet
If 'An IP address could not be obtained
automatically.Would you like to enter your
network settings manually?' appears
Press the red button (SUBTITLE) on the remote control to
1
connect again to the Internet automatically. Always try this
solution first. If necessary, repeat this step several times.
If the Streamium System connects to the Internet, continue
2
with chapter "Registration. "
If the Streamium System does not connect to the Internet,
press the green button (ANGLE) on the remote control to
enter the IP settings manually. Please contact your Internet
service provider to get all the information you need below.
Next, you will be asked to enter
– the IP address for the Streamium System
– the netmask: Make sure all computers in your network,
as well as the Streamium System, have the same
netmask. If you are not sure, try 255.255.255.0.
– Default Gateway:The IP address of your router
– two DNS.
Use the number buttons on the remote control to enter
each setting and press 2OK to confirm each setting.
If 'The system could not connect to the server.'
appears
Maybe the system does not connect to the Internet
because your Internet service provider uses a proxy.You
need to enter the proxy name and proxy port. Please
contact your Internet service provider to get this
information.
Press the green button (ANGLE) on the remote control if
1
your Internet service provider uses a proxy.
Use the number buttons to enter the proxy name. Next,
2
press 2OK.
Use the number buttons to enter the proxy port. Next,
3
press 2OK.
The Streamium System tries to connect to the Internet.
PC LINK connection
After the Streamium System has connected successfully to
the Internet, press PC LINK to connect to the PCs in your
network.
The Streamium System may not connect to the PC
because
– a connection error has occurred. Press PC LINK again.
– you have not yet installed the Philips Media Manager
software on your PC.
– the PC is switched off.
Advertisement
Table of Contents
