Note
f Set the [PROJECTOR SETUP] menu → [COMPUTER2 SELECT] to [COMPUTER2 IN] when a signal is to be input to the <COMPUTER 2
IN/1 OUT> terminal. When [COMPUTER2 SELECT] is set to [COMPUTER1 OUT], it cannot switch to COMPUTER 2 input.
f If one of COMPUTER 1 / COMPUTER 2 / HDMI 1 / HDMI 2 input is selected and no signal is input, the following screen is displayed. Check
the output setting of your computer.
Switching the input with the control panel
The input can be switched with the <INPUT SELECT> button on the control panel
After pressing the <INPUT SELECT> button, the detailed or simple input guide is displayed.
1)
Press the <INPUT SELECT> button on the control panel.
f The input guide is displayed.
2)
Press the <INPUT SELECT> button again.
f Every time you press the <INPUT SELECT> button, the inputs are switched in the following order.
COMPUTER1 → COMPUTER2 → HDMI1 → HDMI2 → VIDEO → COMPUTER1 → ...
f When the detailed input guide is displayed, you can select the input with the qw buttons on the control
panel or on the remote control.
Note
f You can switch the detailed/simple input guide by setting the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [INPUT GUIDE].
f When the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [INPUT GUIDE] is set to [OFF], the input guide is not displayed.
How to adjust the state of the image
If the projected image or the position is not correct when the positioning of the projector and the screen is correctly installed,
adjust the projection angle, zoom, focus and vertical shift.
Zoom lever
Focus lever
Fig. 1
42 - ENGLISH
Chapter 3 Basic Operations - Projecting
Detailed input guide example
Vertical lens shift dial
Fig. 2
Simple input guide example