Panasonic PT-VZ580 Operating Instructions (Functional Manual) page 98

1 [LAMP POWER]
Select the [LAMP POWER] setting.
2 [AUTO POWER SAVE]
Select [ON] to set [AMBIENT LIGHT DETECTION],
[SIGNAL DETECTION], and [AV MUTE DETECTION].
3 [AMBIENT LIGHT DETECTION]
Enable ([ON])/disable ([OFF]) the ambient light
detection function.
4 [SIGNAL DETECTION]
Enable ([ON])/disable ([OFF]) the signal detection
function.
Note
f For details of each setting item on the [ECO management set up] page, refer to the [PROJECTOR SETUP] menu → [ECO MANAGEMENT].
Æ
( page 77)
[E-mail set up] page
When there is a problem or the runtime of a luminous lamp reaches a set value, an E-mail can be sent to the
preset E-mail addresses (up to two addresses).
Click [Detailed set up] → [E-mail set up].
1 [ENABLE]
Select [Enable] to use the E-mail function.
2 [SMTP SERVER NAME]
Enter the IP address or the server name of the E-mail
server (SMTP). To enter the server name, the DNS server
needs to be set up.
3 [MAIL FROM]
Enter the E-mail address of the projector. (Maximum 63
characters in single byte)
4 [MEMO]
Enter information such as the location of the projector that
notifies the sender of the E-mail. (Maximum 63 characters
in single byte)
98 - ENGLISH
Chapter 5 Operation of Function - Web control function
5 [AV MUTE DETECTION]
Enable ([ON])/disable ([OFF]) the AV mute detection
function.
6 [POWER MANAGEMENT]
Select the [POWER MANAGEMENT] setting.
7 [TIMER]
Select the time until the luminous lamp is turned off when
the power management function is activated.
8 [Submit]
Updates the setting.
5 [MINIMUM TIME]
Change the minimum interval for the temperature warning
E-mail. The default value is 60 minutes. In this case,
another E-mail will not be sent within 60 minutes after
sending the temperature warning E-mail even if it reaches
the warning temperature.
6 [INTAKE AIR TEMPERATURE]
Change the temperature setting for the temperature
warning mail. A temperature warning E-mail is sent when
the temperature exceeds this value.
7
8
1
2
3
4
5
6
7
8
9