Replacing A Drum Cartridge - Xerox Versant 180 Press User Manual

2. Open the front door of the press.
3. Open the Dry Ink/Toner Waste Bottle Door.
4. Grasp the handle of the Dry Ink/Toner Waste bottle and pull it halfway out of the
press.
5. Support the underside of the bottle with your other hand and continue pulling it out
from the press.
Caution
Never use a vacuum cleaner when cleaning up spilled dry ink/toner. Use a broom or
a cloth moistened with a neutral detergent.
6. Use both hands to place the old used Dry Ink/Toner Waste Bottle into the provided
plastic bag.
7. Remove a new, empty waste bottle from the packaging.
8. Hold the center part on the top of a new bottle and insert it evenly and gently into
the press until it comes to a stop.
9. Close the waste bottle door.
10. Close the press front door.

Replacing a Drum Cartridge

Other than replacing a drum cartridge after 348,000 prints, you may need to replace a
drum cartridge if it is damaged by light or you are experiencing spots and streaks on
your output.
Note
All four Drum cartridges are interchangeable.
Note
After replacing the drum cartridge, the system automatically resets the usuage counter
of this CRU component to zero (0). Check the Consumables screen for the reset and new
status.
Caution
Do not leave the Drum Cartridge Drawer open for more than one minute. Exposing the
drum cartridges to direct sunlight or strong light from indoor fluorescent lighting for
more than one minute may cause image quality defects.
® ®
Xerox Versant 180 Press
User Guide
Maintenance
5-9