Mobile Home; Shipping Bracket - Napoleon GVFS60P Installation And Operating Instructions Manual

1.5

MOBILE HOME

Suitable for mobile home installation where the mobile home has been permanently placed on its site.
This heater may be installed in an aftermarket permanently located, manufactured (mobile) home, where not
prohibited by local codes.
For mobile home installations, the heater must be fastened in place. It is recommended that the heater be
secured in all installations. See "REPLACEMENTS" section for the levelling / securing kit specifi c to your
heater.
1.6

SHIPPING BRACKET

THE TOP CASTING IS NOT FASTENED TO THE APPLIANCE ASSEMBLY. IT SIMPLY SITS ON THE
APPLIANCE AS A LID. FOR SHIPPING PURPOSES IT IS HELD IN PLACE BY PLASTIC STRAPPING.
ONCE THE STRAPPING IS CUT, THE TOP SHOULD BE LIFTED OFF CAREFULLY AND STORED IN A
SAFE PLACE TO AVOID DAMAGE WHILE COMPLETING THE INSTALLATION OF THE APPLIANCE.
TO AVOID THE APPLIANCE BEING DAMAGED DURING SHIPPING, A SHIPPING BRACKET HAS BEEN
USED AND MUST BE UNBOLTED BEFORE THE APPLIANCE CAN BE INSTALLED.
SHIPPING BRACKET REMOVAL
A. Remove the four screws holding the shipping bracket to the bot-
tom of the appliance.
B. Lift the appliance off the skid and set on a fl at surface.
C. Discard the screws, brackets and skid.
WARNING
!
29.2
SHIPPING BRACKET
W415-0796 / 05.15.09
7